If you prefer to print a hard copy form click here.

Minimum flaw criteria (for crack test)

Describe cycle time: How many parts per second, minute, hour, day? How many hours per day of continuous operation?

Type of test Offline Inline Static Dynamic

Type of installation New Upgrade to existing Replacement of existing

• Part orientation as it is introduced to the test location
• Specific locations on the part that are to be tested
• Footprint of space that the system will occupy (LxWxH)
• Part entrance and exit locations and heights (with XY coordinates relative to footprint)
• Expected flaw location/orientation
• Minimum flaw size that must be detected (depth, length, width) for each test location
• Hardness/case depth deviation measurements required

Describe

Do you already use eddy current equipment? Yes No

If so, what brand/manufacturer?

• Parts that are submitted for a feasibility study must include a representation of good parts that include the range of normal and acceptable variation that would occur in real world production. These acceptable variations would include: heat-to-heat variations, surface condition variations, processing variations, etc.
• Defective (or "bad") samples should be taken from actual production if possible and should represent the range of defective conditions that are encountered in normal production.
• For case pattern verification we will require part drawings for each part that is to be tested and/or sectioned and etched samples that clearly show the correct case hardness pattern.
• Upload RFQ with specification documents (see Upload area above).
• Please indicate if the submitted parts are to be returned. If so, provide shipping details and shipping authorization.

Enter letters/numbers as you see them, then click submit